charu
@charu
Student
Joined: March 8, 2020 10:47 am
Last seen: October 11, 2020 7:08 pm
Topics: 3 / Replies: 7
Reply
RE: Initial and boundary condition for temperature in Fluid.

@negativevolume we can use the initial temperature boundary condition for the combined structural and thermal simulation. In my case what I found o...

3 years ago
Topic
Replies: 0
Views: 610
Reply
RE: Error "severe (157): Program Exception - access violation"

also here is a good discussion on the same topic. you can use model checking tool in ls prepost to check if there is any error.

4 years ago
Reply
RE: Error "severe (157): Program Exception - access violation"

Hi, usually its a problem with contact or material model used. I have found some info online. This may help.

4 years ago
Reply
RE: Rigid Part Constrained by *RIGIDWALL Card

If it still does not work, I think you would have defined a boundary condition for the motion of the rigid body. In that case, the contact does not wo...

4 years ago
Reply
reply

Hi, I think RIGID_PLANAR card should work with rigid bodies as well. If you are having problems, try adding the node set ID of the rigid part specif...

4 years ago
Reply
RE: Simulating Hydrostatic Pressure in ALE2D Analysis

Hi, I cannot see your attached files. can you attach it again?

4 years ago
Reply
RE: Injection molding help

@if4ou Thanks for your reply. I will post the result once I am finished.

4 years ago
Topic
Replies: 2
Views: 828