@icebreakersours Thank you so much for the reply. That didn't work. However, I tried other contact types.

@negativevolume Thanks for the reply. The slave side is the beam, and the master side is the rigid surface!

Does anyone have any idea about this post! Thanks;

@icebreakersours Thanks for the complete reply. I could reduce the oscillations significantly by adding global damping around 10-15% of the critica...

The LS-DYNA support page is written: "The ASCII output file NCFORC reports contact forces at each node. The command *DATABASE_NCFORC is required in th...

@sbrrr Thanks for the reply!

@rybask1 Thank you so much for the reply. Yes, exactly. It was my mistake to activate the dynamic relaxation. Kind regards,

As far as I know, the problem does not relate to LS-Run. I tried other files, and everything is okay. The problem is just with this k file. Another th...

@djsburra Thanks you so much for the reply.

Hi djsburra, Would you please let us know if you could have solved the problem of exporting *.k files from Hypermesh? Thanks,

@djsburra Hello, I just installed the free Hyperworks student version by Altair University, and still, I see the problem you had previously is there. ...

Hello Everyone, If I am right, LS-DYNA is not a powerful tool for meshing. I am trying to find the right tool for meshing 3D arterial geometries in ...

@negativevolume As always, your help is appreciated!

To speed up the simulations in ANSYS LS-DYNA (student version), what is your suggestion? Currently, a simple case takes almost a few hours (on a pc wi...

@negativevolume Again, thanks so much for the support. Best of luck,