Hi @negativevolume, I did not know about *Load_Mask; I will try that and say if it make changes. Thank you. I've also uploaded my prescribed loadi...

Hi @negativevolume, In my ASCII output (*elout) I get negative pressure on the same region that I applied positive pressure. Also, the absolute valu...

Hi @negativevolume, I have the same problem, but I do not use *Mat_add_Erosion. I used *Contact 2D automatic node to surface but I got different re...

@geardyn-1 Thank you for your reply. I had created a 3D model before, but I had not used EOS in my model. I will apply it then. I could not valid...

@mass Got it! yeah, it corresponds with the exit point in my model. Thank you so much!

@icebreakersours There is an example of "Projectile penetrates a plate" in LS-DYNA samples, but it also shows the contact force equal to zero througho...

Thank you @mass. Is it the exit velocity of the projectile from the plate, right? I mean, I should find the moment of exiting the projectile first ...

@mahmoud Thank you very much. I tried *CONTACT_FORCE_TRANSDUCER_PENALTY and it worked. I tried it besides two types of contact: 1)Automatic_Surface_to...

@mahmoud Thank you for the explanation. I tried this contact but after running the model, the projectile passes through the plate without any impact. ...

@mahmoud, I tried your suggested contact_Automatic_Single_Surface, but it doesn't result in any contact between the plate and the projectile. Would yo...

Hi Sarvin, I am modeling a high velocity impact between a bullet and a plate as well. Can I ask how we can obtain the residual velocity after runni...