Notifications
Clear all
Ansys / LS-DYNA Help Forum
2
Posts
2
Users
0
Reactions
632
Views
December 20, 2023 4:28 am
Hi
I want to connect pipe to a tank. I was able to create a hole in the tank shell like below using part trim.
Now I need to create another circle around that hole to model a reinforcing plate like below:
The problem is that there remains some gaps and the circle does not actually lies on the curved surface.
Does anyone know how I can do that? Thanks again.
1 Reply
January 18, 2024 4:03 pm
Hi @mmia1,
You can use Element Generation (EleGen) in the Mesh toolbar in LS-Prepost to extend a shell mesh from a mesh edge or curve.