@negativevolume we can use the initial temperature boundary condition for the combined structural and thermal simulation. In my case what I found o...

also here is a good discussion on the same topic. you can use model checking tool in ls prepost to check if there is any error.

Hi, usually its a problem with contact or material model used. I have found some info online. This may help.

If it still does not work, I think you would have defined a boundary condition for the motion of the rigid body. In that case, the contact does not wo...

Hi, I think RIGID_PLANAR card should work with rigid bodies as well. If you are having problems, try adding the node set ID of the rigid part specif...

Hi, I cannot see your attached files. can you attach it again?

@if4ou Thanks for your reply. I will post the result once I am finished.